SP4xxx: Scanner
SM 5-43 D017/D018/D019/D020
Service
Tables
0: Off. No dust warning.
1: On. Dust warning. This warning does not stop the job.
Before switching this setting on, clean the ADF scanning glass and
the white plate above the scanning glass.
Detect Level
2
Adjusts the sensitivity for dust detection on the ADF scanning glass. This SP
is available only after SP4020 1 is switched on.
[0 to 8 / 4/ 1]
If you see black streaks in copies when no warning has been issued, raise
the setting to increase the level of sensitivity. If warnings are issued when
you see not black streaks in copies, lower the setting.
Note: Dust that triggers a warning could be removed from the glass by the
originals in the feed path. If the dust is removed by passing originals, this is
not detected and the warning remains on.
3 Correction Level
Selects the level of the sub scan line correction when using the ARDF.
[0 to 4 / 0 / 1 /step]
0: Off, 1: Weakest, 2: Weak, 3: Strong, 4: Strongest
APS Scanner Output Display
4301
Displays the status of the APS sensors and platen/DF cover sensor (see
‘APS Output Display’).
APS A5/LT Size Detection
4303*
Selects if the copier defaults to A5 SEF/LEF if the APS sensor cannot detect
the size of a small original.
[0 to 2/0/1]
0: Not detected as A5
1: Detected as A5 SEF
2: Detected as A5 LEF
To Next Page
Loading...
