SP5xxx: Mode
D017/D018/D019/D020 5-120 SM
[1 to 255/1]
Addr Book Migration (SD -> HDD)
40
This SP moves the address book data from an SD card to the HDD. You must
cycle the machine off and on after executing this SP.
Turn the machine off.
Install the HDD.
Insert the SD card with the address book data in SD card slot C3.
Turn the machine on.
Do SP5846 040.
Turn the machine off.
Remove the SD card from SD card slot C3.
Turn the machine on.
Note
Executing this SP overwrites any address book data already on the HDD
with the data from the SD card.
We recommend that you back up all directory information to an SD card
with SP5846 051 before you execute this SP.
After the address book data is copied to HDD, all the address book data
is deleted from the source SD card. If the operation fails, the data is not
erased from the SD card.
Fill Addr Acl Info.
41
This SP must be executed immediately after installation of an HDD unit in a
basic machine that previously had no HDD. The first time the machine is
powered on with the new HDD installed, the system automatically takes the
address book from the NVRAM and writes it onto the new HDD. However, the
new address book on the HDD can be accessed only by the system
administrator at this stage. Executing this SP by the service technician
immediately after power on grants full address book access to all users.
Procedure
1. Turn the machine off.
2. Install the new HDD.
3. Turn the machine on.
4. The address book and its initial data are created on the HDD
To Next Page
Loading...
