Installation
D361 4 SM
12. Remove the dummy keytop [A] (3rd from the top) and replace it with a facsimile keytop
[B].
13. Attach the G3 decal to the front of the machine.
14. Connect the power cord to the machine.
15. Make sure that the plug is grounded properly at the power source.
16. Switch the machine on.
If you see a message that tells you the SRAM has been formatted (due to a
problem with SRAM), cycle the machine off/on to clear the message.
17. Check the clock settings (date and time) with the User Tools.
1.1.2 G3 INTERFACE UNIT (D361)
Accessory Check
Check the quantity and condition of the accessories against the following list.
To Next Page
Loading...
