Ricoh Aficio MP2550B - Page 746

Error Codes
D361 12 SM
Code Meaning Suggested Cause/Action
Cross reference
 Tx level - NCU Parameter 01 (PSTN)
 Cable equalizer - G3 Switch 07 (PSTN)
 Dedicated Tx parameters - Section 4
0-05
Unsuccessful after
modem training at 2400
bps
 Check the line connection.
 Check the NCU - FCU connectors.
 Try adjusting the tx level and/or cable
equalizer.
 Replace the FCU or NCU.
 Check for line problems.
Cross reference
 See error code 0-04.
0-06
The other terminal did
not reply to DCS
 Check the line connection.
 Check the FCU - NCU connectors.
 Try adjusting the tx level and/or cable
equalizer settings.
 Replace the NCU or FCU.
 The other end may be defective or
incompatible; try sending to another
machine.
 Check for line problems.
Cross reference
 See error code 0-04.
0-07
No post-message
response from the other
end after a page was
sent
 Check the line connection.
 Check the FCU - NCU connectors.
 Replace the NCU or FCU.
 The other end may have jammed or run out of
paper.
 The other end user may have disconnected
the call.
 Check for a bad line.
 The other end may be defective; try sending to