Bit Switches
SM 73 D361
Fax Option
Type 3350
D361
I-fax Switch 00 (SP No. 1-102-001)
No Function Comments
1 B4
2 A3
3-6 Reserved
7 Not used
If more than one of these three bits is set to "1",
the larger size has priority. For example, if both
Bit 2 and Bit 1 are set to "1" then the maximum
size is "A3" (Bit 2).
When mail is sent, there is no negotiation with
the receiving machine at the destination, so the
sending machine cannot make a selection for
the receiving capabilities (original width setting)
of the receiving machine. The original width
selected with this switch is used as the RX
machine's original width setting, and the
original is reduced to this size before sending.
The default is A4.
If the width selected with this switch is higher
than the receiving machine can accept, the
machine detects this and this causes an error.
I-fax Switch 01 (SP No. 1-102-002)
No Function Comments
Original Line Resolution of TX
Attachment File
These settings set the maximum resolution of
the original that the destination can receive.
0 200x100 Standard
1 200x200 Detail
2 200x400 Fine
3 300 x 300 Reserve
4 400 x 400 Super Fine
5 600 x 600 Reserve
0: Not selected
1: Selected
If more than one of these three bits is set to "1",
the higher resolution has priority. For example,
if both Bit 0 and Bit 2 are set to "1" Then The
Resolution is set for "Bit 2 200 x 400.
To Next Page
Loading...
