Basic Operation
D366 24 SM
The skew correction sensor does not turn off even if the original was
fed by the maximum length of the original + 150 mm after the skew
correction sensor turned on.
The registration sensor does not turn off even if the original was fed by
its length x 1.5 after the registration sensor turned on.
Sensor stays
on too long
The exit sensor does not turn off even if the original was fed by its
length x 1.5 after the exit sensor turned on.
The skew correction sensor does not turn on even if the original was
fed by transport path length x 1.5.
The registration sensor does not turn on even if the original was fed by
transport path length x 1.5 after the skew correction sensor turned on.
Sensor does
not come on
The exit sensor does not turn on even the original was fed by transport
path length x 1.5 after the skew correction sensor turned on.
To Next Page
Loading...
Need help?
General