Image Transfer
M018/M019 4-18 SM
6. Pull out the image transfer belt unit [D] (
x 2).
After replacing the image transfer belt unit
Do the following step 2 with the front cover of the machine open.
1. Open the front cover and turn on the machine.
2. Execute "Reset Transfer Unit Life Counter" with the "Engine Maintenance" menu.
3. Close the front cover.
4. Execute "Trans. Belt Adjust" with the "Engine Maintenance" menu.
5. Adjust the registration settings for each tray and for the front and rear sides of the paper
with the "Engine Maintenance" menu if necessary.
http://www.manuals4you.com
To Next Page
Loading...
