EasyManuals Logo

Ricoh Aficio SP C232DN User Manual

Ricoh Aficio SP C232DN
288 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #123 background imageLoading...
Page #123 background image
Troubleshooting
102
8
Prints do not stack properly. Paper is damp. Use paper that has been stored properly.
See p.37 “Paper and Other Media”.
Pull out the extender.
Perform the following operation.
Press the {Menu} key on the control panel, select [Sys-
tem], and then press the {#Enter} key.
Press the {T} or {U} key and select [Anti-Humidity], and
then press the {#Enter} key.
Press the {T} or {U} key and select [Mode 2] or [Mode
3], and then press the {#Enter} key.
Note that the first print takes longer than subsequent
prints to complete.
See the printer driver help.
Raise the appropriate stop fence (forward fence for A4,
rear fence for legal size prints).
See, p.1 “Exterior: Front View”.
Multiple pages are fed at once. There may be a gap between the front end paper guide
and paper, or between the paper guide both side and pa-
per in the paper tray. Make sure there are no gaps.
See p.47 “Loading Paper”.
Paper is either too thick or too thin.
See p.37 “Paper and Other Media”.
Paper has already been printed on.
See p.37 “Paper and Other Media”.
Number of paper set in the tray exceeds the limit. Con-
firm that the top of the stack is not higher than the limit
mark inside the tray.
See p.37 “Paper and Other Media”.
Paper is static. Use paper that has been stored properly.
See p.37 “Paper and Other Media”.
The friction pad or paper feed roller or registration roller
may be dirty. Clean the pertinent section as necessary.
See p.86 “Cleaning the Friction Pad and the Paper Feed
Roller”
Check that paper has not been added while there is still
some left in the tray.
Only add paper when there is none left in the tray.
Fan the paper before loading.
Paper gets wrinkles. Paper is damp. Use paper that has been stored properly.
See p.37 “Paper and Other Media”.
Paper is too thin.
See p.37 “Paper and Other Media”.
There may be a gap between the front end paper guide
and the paper, or between the paper guide both side and
the paper in the paper tray. Make sure there are no gaps.
See p.47 “Loading Paper”.
Status Possible Causes, Descriptions, and Solutions

Table of Contents

Other manuals for Ricoh Aficio SP C232DN

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ricoh Aficio SP C232DN and is the answer not in the manual?

Ricoh Aficio SP C232DN Specifications

General IconGeneral
BrandRicoh
ModelAficio SP C232DN
CategoryPrinter
LanguageEnglish

Related product manuals