Other Printing Problems
103
8
Images are not printed in the
right position
• Adjust the printing position.
You can adjust the printing position of tray 2 using the
control panel.
See Software Guide.
• Adjust the front end paper guide and both side paper
guides to match the paper size.See p.47 “Loading Paper”
Images are printed diagonally
to the pages
Adjust the front end paper guide and both side paper guides
to match the paper size.
p.47 “Loading Paper”.
White lines appear. The intermediate transfer belt is dirty.
Follow the procedure below to clean the belt:
Open the top cover while the power is on.
Remove all print cartridges from the printer.
Close the top cover with both hands carefully.
When cleaning finishes, open the top cover and reinsert
all the print cartridges.
If this procedure does not resolve the problem, contact your
sales or service representative.
Horizontal lines appear on the
printed paper.
• Impact can cause lines to appear on printed paper and
other malfunctions.
Protect the printer from impact at all times, especially
while it is printing.
• If lines appear on prints, turn the printer off, wait a few
moments, and then turn it back on again.
Then, perform the print job again.
White spots appear. • The surrounding registration roller or paper tray can be-
come dirty with paper dust if you use other than stand-
ard paper. Wipe any paper dust off both the paper tray
and registration roller.
See p.89 “Cleaning the Registration Roller and the Paper
Tray”.
Status Possible Causes, Descriptions, and Solutions
ASH102S
ASH103S
ASH104S
To Next Page
Loading...
Need help?
General