7. With the label side facing left, slowly push the card adapter into the interface unit until it
stops.
• Confirm that the Bluetooth interface unit was correctly installed by printing the configuration page. If
it is correctly installed, "Bluetooth" will appear for "Device Connection" on the configuration page.
• If the board was not installed properly, repeat the procedure from step 2. If it cannot be installed
correctly even after reattempting installation, contact your sales or service representative.
• For details, see the operating instructions included with the Bluetooth interface unit.
• For information on printing the configuration page, see "Test Printing", Quick Installation Guide.
• "Test Printing", Quick Installation Guide
Installing the Bluetooth Interface Unit
51
To Next Page
Loading...
