• Make sure paper is not stacked higher than
the paper guides inside the bypass tray.
Duplex printing Not supported
Envelope setup
Default: [Envelope 1]
If the print quality needs to be improved, select a
paper type that is appropriate for the thickness of
the envelope you are using. Select [Maintenance]
[General Settings] [Envelope Setting] [En-
velope 1] to [Envelope 3].
High numbered settings allow thicker paper to be
used, but are printed more slowly.
Additional cautions
• Load envelopes with the print side down, and
the open end of the envelope facing out from
the printer.
• When printing on envelopes, set the envelope
size using the printer driver or control panel.
See p.110 "Loading custom size paper" for
details.
• Before loading envelopes, remove any air in-
side and make sure all edges are sharply
creased. If envelopes are curled, straighten
them before loading.
• If envelopes are curled when they are output,
straighten them by rubbing.
• Depending on the printing environment, en-
velopes may be output with the edges wrin-
kled, with toner marks on the back, or blurred.
In addition, when printing solid black areas,
streaks may appear where two envelopes
touch.
• Depending on the type of envelope or printing
environment, envelopes might be output
creased or printed improperly. In such cases,
try changing the loading orientation.
5. Paper and Other Media
94
To Next Page
Loading...
Need help?
General