Ricoh Aficio SP C830DN User Manual

Message Cause Solution
"Print overrun." Images were discarded
while printing.
Select a lower resolution on the printer
driver. For details about how to change
the resolution setting, see the printer
driver Help.
"Printing privileges have not
been set for this document."
The PDF document you have
tried to print has no
privileges to print.
Contact the owner of the document.
"Punch has been cancelled." Punch printing was
canceled.
Check the paper orientation, print
orientation, and then punch position.
Certain settings can produce print
results that might not be as expected.
"Receiving data failed." Data reception was
aborted.
Resend the data.
"The selected paper size is
not supported. This job has
been cancelled."
Job Reset is automatically
performed if the specified
paper size is incorrect.
Specify the correct paper size, and
then print the file again.
"Sending data failed." The printer received a
command to stop
transmission from the printer
driver.
Check if the computer is working
correctly.
"Staple has been
cancelled."
Stapling printing was
canceled.
Check the paper orientation, paper
quantity, print orientation, and staple
position. Certain settings can produce
print results that might not be as
expected.
"The print job has been
cancelled because capture
file(s) could not be stored:
Exceeded max. memory."
The hard disk became full
after a file was stored.
Reduce the file size to be sent.
"The selected paper type is
not supported. This job has
been cancelled."
Job Reset is automatically
performed if the specified
paper type is incorrect.
Specify the correct paper type, and
then print the file again.
3. Troubleshooting
102

Ricoh Aficio SP C830DN Specifications