3. On each side of the unit, insert the pin [1] through the arms of the joint bracket À into the hole in the
lower folder positioning bracket Á.
• If the pins cannot be inserted because the holes are not aligned, use a wrench to turn the nuts
on the legs under each corner of the fan fold unit until the holes are aligned.
•  and à must both be adjusted with the same number of turns.
• Ä and Å must both be adjusted with the same number of turns.
4. Remove both pins after you make sure that they can be easily inserted.
Folder FD6500B (Cross Folder) (B890)
165
To Next Page
Loading...
