[0 or 1 / 0 / 1/step]
0: Disable, 1: Enable
5990 SP Print Mode (SMC Print) GW
In the SP mode, press Copy Window to move to the copy screen, select the paper size,
then press Start. Select A4/LT (Sideways) or larger to ensure that all the information prints.
Press SP Window to return to the SP mode, select the desired print, and press Execute.
1 All (Data List)
2 SP (Mode Data List)
3 User Program Data
4 Logging Data
5 Self-Diagnostic Report
6 Non-Default (Prints only SPs set to values other than defaults.)
7 NIB Summary
8 Capture Log
21 Copier User Program
22 Scanner SP
23 Scanner User Program
SP6000 Peripherals
6117 Folder Input Check
This SP retrieves the SP settings of each bit within 0.5 sec., collects the data into 1-byte, then
sends it to the controller. However, undefined sensor information on the Folder unit side is set
to "0" without checking the Folder unit.
• If there is no response from the Folder FD within the prescribed time after it is checked, the
1-byte data (sensor information) is set to "0".
• The requests for engine information stop after this SP screen is closed.
(7) 0000 0000 (0)
8. Appendix: SP Mode Tables
200
To Next Page
Loading...
