• Re-install the left end first (viewed from the front).
Roll Tray
Preparation
• The roll tray weighs 36 kg (80 lb.) At least two technicians are needed to remove it and re-install it.
• Prepare a clean flat surface to set the unit on after removal. The paper feed motor is mounted under
the roll tray. A strong table, or four blocks, to raise the roll tray slightly, is ideal and will make it easier
to service.
• Right rear cover, right front cover * p.259
• Rear cover * p.264
• Controller box cover * p.265
1. Remove:
[1] Open the harness clamps ( x 6)
[2] Connectors ( x 2)
4. Replacement and Adjustment
326
To Next Page
Loading...
