This SP adjusts the standby position where the tray receives output after the tray upper limit
sensor goes OFF. Raising this setting lowers the tray standby position, lowering the setting
raises the position.
[0 to 50/25/5]
6975 Punch Position Adjustment (Japan Only)
6976 Stamp Adjustment (Japan Only)
6991 Folder Counter
These SP codes display the counts for each item listed below in the range: 0 to 9999 9999,
1 Fan Folder Sheet Count
Number of sheets through the fan folder (with or
without folding)
2 Cross Folder Sheet Count
Number of sheets through the cross folder unit
(with or without folding)
3 Fan Fold Count Number of folds done by fan folder.
4 Corner Fold Count
Number of folds done by corner folder. (Japan
Only)
5 Cross Fold Count Number of folds done by cross folder.
6 Punch Count (Vert)
Number of vertical punches (2 holes across
direction of feed)
7 Punch Count (Horiz)
Number of vertical punches (2 holes parallel to
direction of feed)
8 Stamp Counter Japan Only
SP7000 Data Log
7001 Main Motor Operation Time
Displays the drum drive motor operation time (for checking the print count and drum operation
time.)
7401 Total SC Counter
8. Appendix: SP Mode Tables
228
To Next Page
Loading...
