Ricoh BE-C1 D046 - Page 675

6973 Invert/Rotate Adj: Cross
1
Rotation Time
This SP adjusts the rotation time. Raising the setting increases the rotation time. The table below
shows the time adjustments for both 90 and 180 rotation.
[-15 to +15/0/0.7 degrees]
2
Rotation Time : Large Size
A0 SEF: Standard, Narrow Std.:
Eng. Size SEF (44x32): Margin Fold, Standard Fold
Eng. Size SEF (48x36): Margin Fold, Standard Fold
For these 3 sizes (x 2 = 6 patterns), increasing SP6973-1 adusts the amount of rotation. The
times calculated for SP6973-1 are shown in the table below.
[-15 to +15/0/0.7 degrees]
11
Paper Halt Position During Rotation
The position where the paper is stopped at the center for rotation can be adjusted in the range
±10 mm. Raising the setting increases the amount of rotation before the paper stops.
[-10 to +10/0/0.5 mm]
12
Paper Halt Position During Rotation: Large Size
A0 SEF: Standard, Narrow Std.:
Eng. Size SEF (44x32): Margin Fold, Standard Fold
Eng. Size SEF (48x36): Margin Fold, Standard Fold
For these 3 sizes (x 2 = 6 patterns), increasing SP6973-11 adusts the center stop position
for rotation.
[-15 to +15/10/1 mm]
21
Paper Halt Position During Inversion
During inversion the inverter motor stops once the trailing edge of the paper passes the inverter
entrance sensor and feeds 129 mm.
This 129 mm distance that the paper feeds can be adjusted in the range 0 to +15 mm.
Raising the setting increases the distance that the paper feeds.
[0 to 15/0/1 mm]
6974
Shift Tray Adjustment : Stand-by Position
System Service Mode
227
8