The width of the 2nd folded surface can be adjusted in the range ±10 mm. Raising the setting
increases the width of the fold.
[-10 to +10/0/0.5 mm]
53
3rd Fold
The width of the 3rd folded surface can be adjusted in the range ±10 mm. Raising the setting
increases the width of the fold.
[-10 to +10/0/0.5 mm]
61
Margin Fold Finish Length: 3rd Fold
The width of the 2nd folded surface can be adjusted in the range ±10 mm when the paper is
cross folded three times with a margin. Raising the setting increases the width of the fold.
[-10 to +10/0/0.5 mm]
62
Margin Fold Finish Length: 5th Fold
The width of the 4th folded surface can be adjusted in the range ±10 mm when the paper is
cross folded 5 times with a margin. Raising the setting increases the width of the fold.
[-10 to +10/0/0.5 mm]
63
Margin Fold Length: 3rd Fold: A2 LEF
The width of the 3rd folded surface can be adjusted in the range ±10 mm when A2 LEF is cross
folded with a margin. Raising the setting increases the width of the fold.
[-10 to +10/0/0.5 mm]
71
Cross Std/Pack Size Fold Length: 1st Fold: A0 SEF
This SP adjusts the width of the 1st cross folded surface for A0 SEF, Standard Folded or Narrow
Std. Folded. The higher the setting, the greater the side of the fold.
[-20 to +20/-3/0.5 mm]
72
Std/Pack Size Fold Length: 2nd Fold: A1 SEF
This SP adjusts the width of the 2nd cross folded surface for A0 SEF, Standard Folded or Narrow
Std. Folded. The higher the setting, the greater the side of the fold.
[-20 to +20/-1.5/0.5 mm]
81
Fan Fold Selection: Peak or Valley
This SP selects the cross fold direction for 2T margin folded paper. Select "0" for a valley fold,
select "1" for a peak fold.
[0 to 1/0/1]
8. Appendix: SP Mode Tables
226
To Next Page
Loading...
