Tray and Stacker Options
• After installation of the original exit tray or stacker at the rear, go into the SP mode and switch of
SP4975 (Original Edge Hold). Otherwise, only one original can be fed at a time.
Original Exit Tray Type G (B341)
• This option cannot be used when Folder FD6500 A/B (B889/B890) is installed.
Accessory Check
No. Description Q’ty
1 Base Strut Frame 2
2 Base Struts 2
3 Middle Struts 2
4 Tray Struts 2
5 Original Tray 1
6 Size Decal Sheet 1
7 Original Stoppers 2
8 Original Guides 2
9 Caps – Base Struts 2
10 Caps –Tray Struts 2
11 Hexagonal Bolt – M8 x 40 12
12 Washer – 8 mm 20
13 Tapping Screw – M4 x 8 6
14 Hex Nut – M8 8
15 Caster – φ40 2
2. Installation
76
To Next Page
Loading...
