28. Set the ends of the side copy tray supports [A] (x5) into the side copy tray bracket [B].
29. Slide the groove on the end of each copy tray support into the slots [C] in the side of the transport
unit.
30. Position the side copy tray brackets and supports so that the bracket is parallel to the side of the
transport unit and the supports are evenly spaced.
31. Set the rear copy tray supports [A] (x3) and wide guide mylars [B] in the holes at the top of the transport
unit [C].
32. Make sure that the strip mylars [D] overlap the wide guide mylars.
2. Installation
180
To Next Page
Loading...
