9. Turn the connector [1] to match the shape of the D-connector on the left side of the CIS board [2].
10. Connect the cable to the left side of the CIS board (x1).
11. Make sure there is no slack in the cable between the left side of the main machine and the CIS board.
12. Clamp the cable at [3] (x1).
13. Attach the ferrite core [1].
Printer Relay Board, Cable Connection
1. At the rear of the main machine, attach the printer relay board [1] above the IOB (x3 M3).
2. Installation
242
To Next Page
Loading...
