2. Remove:
[1] Left cap (tab release)
[2] Right cap (tab release)
[3] Paper guides
• Note the position of each guide before removal. Each guide must be installed at its original
position.
• To remove a paper guide, lift it slightly and move it toward the center.
[4] Transfer wire
[5] Separation wires
Reinstallation
• Each paper guide pair must be installed at the original position.
• For each pair, the high guide is set on the outer side, and the low guide is set on the inner side.
• Paper will wrinkle if the guides are not installed at their original positions.
• Remove the T/S corona unit carefully, to avoid touching or scratching the OPC drum above.
• The single wire at the front and the double wire at the back are both spring-loaded on the left.
• Make sure the wires are correctly positioned in the correct slots and not crossed.
• If replacing wires, hold them by the ends. Oil from hands could cause uneven charge on the drum.
• Handle wires carefully. Never bend or stretch them.
4. Replacement and Adjustment
338
To Next Page
Loading...
