• On the left measure the distance from the right edge of the first block to the right edge of the 76th
block. This should be 812.8±3 mm.
3. If the main scan measurement (down) is not 997±3 mm do SP2916-1 to adjust it.
4. If the sub scan measurement (left to right) is not 812.8±3 mm do SP2916-2 to adjust it.
5. Repeat this procedure until the measurements are within standard.
6. After the measurements are within standard, adjust the following SP codes with the same value you
used to adjust SP2916-1:
• SP2916-7
• SP2916-9
• SP2916-15
7. Next, adjust the following SP codes with the same value you used to adjust SP2916-2:
• SP2916-8
• SP2916-10
• SP2916-16
(3) Print and Erase Margin Setting
1. Execute SP5990 002 to print the SMC Copy List (a list of the SPs).
2. Set the following SPs to the settings below to make measurement easier.
SP Name Setting
2101-1 Printing Erase Margin – Leading Edge 2 to 5
2101-3 Printing Erase Margin – Left Edge 2 to 5
4012-5 Scanner Erase Margin – DF Leading Edge 1.5 to 0
4012-7 Scanner Erase Margin – DF Left 1.5 to 0
Important Adjustments
417
To Next Page
Loading...
