8. Touch the key for the item that you want to update: (1) System/Copy, (2) Engine, (3) Scanner.
• The selected item appears in reverse.
• The "Update(#) touch-key appears to the right of the "Exit" key.
9. Touch [Update (#)] to start the update procedure.
• You will see a series of progress bars (lines of asterisks) appear while the update is in progress.
• When you see "Update done" the update is finished.
10. Update the next item if necessary.
11. When you are finished, turn the copier off and remove the SD card from Slot 2.
12. Turn the copier on, wait for the machine to warm up, then confirm that it is operating normally.
Firmware Update
425
To Next Page
Loading...
