4. Set the other original trays [C] and [D] next to the center tray.
5. Fasten each original tray ( x2 each, round-headed screws).
6. Instruct the operators about this point of operation: Before feeding large originals (larger than A0),
pull the original guide plate [A] out and pull the original guide [B] forward.
Original Trays: Rear Exit
1. Attach an original tray mylar [A] to each tray [B].
• The trays must be installed with the flat side facing up.
2. Attach each tray to the back of the main machine (x2 each).
Main Machine (D046/D049)
41
To Next Page
Loading...
