4. Next, select the target destination where the debug information will be saved. Under “5857 Save
Debug Log”, touch “2 Target”, enter “2” with the operation panel key to select the hard disk as the
target destination, then press .
Select “3 SD Card” to save the debug information directly to the SD card if it is inserted in the service
slot.
5. Now touch “5858” and specify the events that you want to record in the debug log. SP5858 (Debug
Save When) provides the following items for selection.
1 Engine SC Error Saves data when an engine-related SC code is generated.
2 Controller SC Error
Saves debug data when a controller-related SC Code is
generated.
3 Any SC Error
Saves data only for the SC code that you specify by entering code
number.
4 Jam Saves data for jams.
More than one event can be selected.
Example 1: To Select Items 1, 2, 4
Touch the appropriate items(s). Press “ON” for each selection. This example shows “Engine SC Error”
selected.
Example 2: To Specify an SC Code
Touch “3 Any SC Error”, enter the 3-digit SC code number with the control panel number keys, then
press . This example shows an entry for SC670.
Using the Debug Log
429
To Next Page
Loading...
