2 Trailing Edge
3 Left Edge
4 Right Edge
2110 Test Mode dpi DFU
This SP adjusts the image resolution. This adjustment is required for Design checking and testing
the FCI operation with the test patterns. Once the machine leaves the SP mode, this SP
automatically returns to its default settings.
[0 to 19/8/1]
2201 Development Bias Adjustment
1
Image Area
Sets the development bias voltage to adjust the toner amount for the image area.
[100 to 1000/650/10V]
2
ID Sensor Pattern: Low Duty Copy Jobs
Sets the development bias to adjust the toner amount for the ID sensor pattern.
[100 to 1000/390/10V]
3
ID Sensor Pattern: High Duty Copy Jobs
Sets the development bias to adjust the toner amount for the ID sensor pattern.
[100 to 1000/440/10V]
4
Copy Jobs
Determines the mode used for generating the ID sensor pattern.
[0 to 1/1/1]
0: Low, 1:High
2207
Forced Toner Supply
Press [Execute] to execute a forced toner supply.
If this switched on, this SP supplies more toner to darken light copies. For every execution,
toner is supplied one time. After doing this SP, make a copy and check the copy density.
8. Appendix: SP Mode Tables
118
To Next Page
Loading...
