• For the Fixed Mode only two selections are available: 1:3% or 2:6%. However, you
can adjust this amount of coverage for either setting. SP2208-5 adjusts the amount of
coverage for selection "1" (3%). SP2208-6 adjusts the amount of cover for selection
"2" (6%). SP2208-7 must be switched on for either adjustment to take effect.
• If the ID sensor is damaged and cannot be replaced immediately, set to 1 or 2 so the
customer can continue to use the machine until a new ID sensor is available for
replacement. After installing a new ID sensor, reset this SP code to 0.
4
Toner Supply Time
This SP determines the length of time that the toner supply clutch remains on to supply toner.
[0 to 1/0/1]
0: Normal
1: Increase Toner Supply Time
Important: If "1" is selected independently all toner is supplied while the development unit
rollers are rotating. This can adversely affect toner supply control.
5
Long Print: Drawing
This SP sets the percent of coverage precisely for drawings when the machine uses the Fixed
Mode (SP2208-3).
[1 to 40/3/1%]
Note:
• If the length of the copy exceeds 1250 mm (49.2 in.) the machine automatically
switches to the Fixed Mode (SP208-3).
• The Long Print: Drawing mode (this SP) and Long Print: Graphic mode (SP2208-6) are
separate. Drawings are originals with large numbers of fine lines, and Graphics are
originals with graphic images that require more solid shading and fill such as photos.
• If the customer is scanning large numbers of drawings, first switch on SP2208-7 (select
"1") then do this SP adjustment to set the percent of coverage.
6
Long Print: Graphic
This SP sets the percent of coverage precisely for graphics when the machine uses the Fixed
Mode (SP2208-3).
[1 to 40/6/1%]
Note:
• If the length of the copy exceeds 1250 mm (49.2 in.) the machine automatically
switches to the Fixed Mode (SP208-3).
8. Appendix: SP Mode Tables
120
To Next Page
Loading...
