4962 Original Speed Calibration by Temperature
Displays the temperature of the original exit roller.
Note: There are two abnormal readings. The thermistor requires servicing if you see either of
these readings:
A 100oC reading means the thermistor is disconnected.
A 0oC reading means the thermistor has shorted.
1 Feed Roller Temperature Display
2 Calibration Value Display
3 Calibration Value Setting DFU
4975
Original Edge Hold
This SP switches the original edge hold function off and on.
[0 to 1/0/1]
0: On. With paper longer than 450 mm (18"), the original exit roller stops and holds the paper
at the trailing edge so it does not fall off the original exit tray.
1: Off. With paper shorter than 450 mm, the rollers do not stop. The paper is allowed to fall
onto the tray.
Note: When the rollers hold the original edge the operator must pull the paper out of the nip
and remove it from the tray before another original can feed.
4991 IPU Image Data Path DFU
1
RGB Frame Memory (Change 1)
[0 to 255/0/1]
0: Dot correction module
1: Gray create module
2: Scanner gamma module
3: Registration adjustment & mirroring module
4: Main scan magnification & left shift/right shift module
5: Multi-rate_filter module
6: Multi-rate_line correction module
7: Multi-rate_independent dot erase module
2 RGB Frame Memory (Change 2)
8. Appendix: SP Mode Tables
150
To Next Page
Loading...
