4. Push the tray in until it stops.
5. At the front left corner of the copier, connect the heater cable [A] to the tray ( x2)
6. Attach the left lock pin [A] and right lock pin [B] in the order that is shown by the numbers ( x2 each).
• Insert the stud of each lock pin first on the left À then on the right Á.
• Check that all 6 holes are aligned correctly before you attach the screws.
• You may need to move the cassette tray slightly to the right or to the left to align the holes.
• Screws  and à are M3 size.
Paper Cassette Type 7140 (D395)
73
To Next Page
Loading...
