171
Changing Camera Settings
5
The following five operation sounds are made during camera
operation.
To change the operation sound setting, follow the steps below.
1
Display the setup menu.
• For the operating procedure, see P.156.
2
Press the " button to select [Operation Sounds] and
press the $ button.
3
Press the !" buttons to select
the desired setting.
4
Press the MENU/OK button, or
press the # button and then
the MENU/OK button.
Note ----------------------------------------------------------------------------------------------
The operation sound setting can be changed. (GP.172)
Changing the Operation Sound
Setting (Operation Sounds)
Start sound : Sound when the camera is turned on.
Shutter release
sound
: Sound when the shutter release button is pressed.
Focus sound : Sound when the shutter release button is half-pressed and the
camera focuses on the subject.
Beep sound : Error sound indicating an operation that cannot be performed.
Level sensor sound : When [Level Setting] is set to [Sound] or [Disp + Snd] (GP.173),
the sound is continually emitted at a set interval when the camera is
level in shooting mode.
Available Settings Description
All *Default setting All sounds on
Shutter Shutter release sound, beep sound, and level sensor sound.
To Next Page
Loading...
