2
Playback Functions
104
Correcting Brightness and Contrast (Level Compensa-
tion)
You can correct the brightness and contrast of taken still images.
1 Display the image to correct in playback mode, and then press
the MENU/OK button.
The [Playback] menu appears.
2 Select [Level Compensation], and then press the $ button.
3 Select [Auto] or [Manual], and then press the $ button.
The original image is displayed on the top left, and the corrected image on
the right.
If you select an image that cannot be corrected, an error message appears
and then the [Playback] menu reappears.
When [Auto] is selected, proceed to Step 6.
4 Press the ADJ. lever to switch the
histogram points.
The points at the left side, center, and right
side are switched.
The histogram indicates the number of pixels
on the vertical axis, and the shadows, mid-
tones, and highlights from left to right on the
horizontal axis.
If the Fn2 button is pressed while this screen
is shown, an explanation of the operations
appears. If the Fn2 button is pressed again, the previous screen reappears.
5 Press the #$ buttons to make point adjustments.
6 Press the MENU/OK button.
A message appears to indicate processing is being performed, and then the
corrected image is saved as a new image.
Points
To Next Page
Loading...
