134
4
Making Use of Images
Pressing and Holding the w Button
1 Set [Effect Button Hold Setting] to [Wi-Fi] in the [Key Custom
Options] menu.
The default setting is [Wi-Fi].
2 Press and hold the w button.
A beep sounds and the Wi-Fi symbol appears
on the shooting screen.
3 Release the w button.
To disable the Wi-Fi function, press and hold the w button again.
Touching a Communication Device
When this camera comes into contact with a communication device
equipped with the NFC function, the camera establishes a Wi-Fi connection.
1 Lightly touch the communication
device to the NFC mark of the
camera.
A beep sounds and the Wi-Fi symbol ap-
pears on the shooting screen.
Caution -------------------------------------------------------------------------------------------------------
• To establish a Wi-Fi connection by touching a communication device, the Wi-Fi function and the NFC
reader/writer function of the device must be enabled in advance. For details on how to operate the
communication device, refer to the operating manual of the device.
Note -----------------------------------------------------------------------------------------------------------
• When the dedicated application “Image Sync” is installed on the communication device, Image Sync
is started by touch operation. Touching the communication device again enables the Wi-Fi function
of the camera. (p.139) When Image Sync is not installed, the download site for the application is
displayed on the communication device.
To Next Page
Loading...
