1. Pull Tray 3 (LCT) out carefully.
2. Square the paper and load it with the print side facing up.
Fan sheets before loading so that multiple sheets of paper do not stick to each other and are not
fed at once.
For the right stack, align the right edge of the paper with the right edge of the tray. For the left
stack, align the left edge of the paper with the left edge of the tray.
Do not stack paper over the limit mark.
When the whole tray can be pulled out
When half of the tray can be pulled out
Load 30 or more sheets of paper in the left half of the tray.
8. Adding Paper and Toner
190
To Next Page
Loading...
