EasyManua.ls Logo

Ricoh MP 161 - Detecting Blank Sheet

Ricoh MP 161
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Transmission
36
1
Maximum scan area
The following shows the maximum scan area:
Memory Transmission: 216 × 1200 mm, 8
1
/
2
" × 47" (W × L) from the ARDF
Immediate Transmission: 216 × 1200 mm, 8
1
/
2
" × 47" (W × L) from the ARDF
210 × 297 mm, 8
1
/
2
" × 14" (W × L) (from the exposure glass)
Note
There may be a difference in the size of the image when it is printed at the destination.
Even if an original is correctly placed on the exposure glass or in the ARDF, a
margin of 3 mm (0.1") around each edge of the original may not be sent.
If the receiver uses paper of a smaller width than the original, the image is re-
duced to fit that paper.
During Immediate Transmission, the length of the scanning range can be-
come narrower than 1200 mm (47"), depending on the resolution as well as
the settings on the destination machine.
Detecting Blank Sheet
Upon completion of the first page scanning, an alarm sounds if the page is nearly
blank.
Important
The blank sheet-detecting function works only when an original is scanned
using the ARDF.
The blank sheet-detecting function is ineffective for second and subsequent
pages.
This function notifies you if an original is placed wrong side down on the scan-
ner. When this happens, a message appears for a few seconds. The message dif-
fers depending on the number of pages to be scanned and transmission mode.
When sending a document using Immediate Transmission or when all pages
have been scanned in Memory Transmission:
When some pages are left unscanned in Parallel Memory Transmission or
Memory Transmission:

Table of Contents

Related product manuals