Transmission
56
1
Checking the Specified Destination
This section explains how to check the specified destinations.
If you specified a destination from the destination list, you can display names,
fax numbers, e-mail addresses, or IP-Fax destinations. If a group is specified as
the destination, you can display the fax numbers, e-mail addresses, or IP-Fax
destinations of the group.
A Make sure the destination name appears on the display.
B Press the {Check Destination} key.
C If you specified more than one destination, display them one by one using
{U} or {T}.
D Press the {OK} key when confirmation is complete.
The display returns to that of step
A
.
Note
❒ If you specified a group using the Quick Dial keys, , the group icon ap-
pears to the right of the destination name by pressing the {Check Destination} key.
❒ When you specify a destination using the number keys, [Program] appears
on the screen by pressing the {Check Destination} key. Press [Program] to
register a selected destination in the destination list.
Reference
p.60 “Programming Destinations from Check Destination Screen”
ASO031S
To Next Page
Loading...
