Send Settings
86
2
D Select [Send at Specified Time] using {U} or {T}, and then press the {OK} key.
To cancel the setting, select [Off], and then press the {OK} key. The display re-
turns to that of step
C
.
E Enter the time using the number keys and press [AM/PM] to switch between
AM and PM. Then press the {OK} key.
When entering numbers smaller than 10, add a zero at the beginning.
If you make a mistake, press the {Clear/Stop} key before pressing the {OK}
key, and then try again.
To cancel Send Later, press the {Escape} key. The display returns to that of
step
C
.
F Press the {Escape} key.
The standby display appears.
To check the settings, press [TX Mode].
G Specify a destination, and then press the {Start} key.
Note
❒ You can specify a time within 24 hours of the current time.
❒ If the current time shown is not correct, change it.
Reference
p.81 “Canceling a Transmission”
“System Settings”, General Settings Guide
“Troubleshooting When Using the Facsimile Function”, Troubleshooting
To Next Page
Loading...
