Ricoh P C300W - Page 174

5.System Maintenance
162
Menu
Description
Number of time to
press
[1 to 3 / 2 / 1step]
Period for TEL to FAX
[Limitless / 10 sec / 20 sec/ 30 sec/ 40 sec]
TX Settings
Redial Interval
Sets the redial interval when Tx fails.
[5 Min / 6 Min]
Redialings
Sets the number of redials when Tx fails.
[2 times / 3 Times / 4 Times / 5 Times]
Overseas
Comm Mode
Settings
Overseas Comm
Mode
This sets the machine to ignore a DIS signal sent from the
called station once in a sending operation.
[Off / Ignore DIS Once]
Minimum Time
Length
If this setting is set to "On", the machine detects the CNG
signal after the line is connected. If it is set to "Off", the
machine detects the CNG signal as long as the line is
connected.
[100 Ms / 200 Ms / 300 Ms / 400 Ms]
Dial Pulse
Setting
Dial Pulse Type
This sets the number of pulses that are generated during
dialing.
• N: Dialing '0' generates 10 pulses --- Dialing '9'
generates 9 pulses.
• N+1: Dialing '0' generates 1 pulses --- Dialing '9'
generates 10 pulses.
• 10-N: Dialing '0' generates 10 pulses --- Dialing '9'
generates 1 pulse.
Tone Signal
Settings
Tone Signal
Transmission Time
Length
Sets the tone signal transmission time length.
[100 ms (Default)]
Minimum Pause in
Tone Dial
Sets the minimum pause during tone dialing.
[100 ms / 150 ms / 200 ms]
Attenuator For
Pseudo RingBack
tone To the Line
Sets the attenuator for pseudo ringback tone to the line.
[0 to 15 / 10 / 1 dB/step]
DTMF Level
Sets the transmission level of DTMF tones.
[-12 dBu / -11 dBu / -10 dBu / -8 dBu / -6 dBu]
DTMF Delta
Sets the level difference between high band frequency
signals and low band frequency signals when sending
DTMF tones.
[2 dBu / 3 dBu]