Error Name/Error Condition/Major Cause/Solution
The requested buffer is full (M)
The requested buffer is full (C)
The requested buffer is full (Y)
An error is notified during the ID identification after three retries.
• Malfunction
• Noise
• ID chip contact failure
Check if the SC occurs by turning the power OFF then ON. If the SC occurs again,
do the following steps. Check if the SC reoccurs by cycling the power after each
step.
1. Check if there is any dirt or abnormality on the ID chip connector. Clean the
connector if it is dirty or replace the ID chip for any abnormalities.
2. Replace the ID chip board (PCB6).
3. Replace the AIO.
4. Replace the harness between the EGB (PCB1) and ID chip board (PCB6).
5. Replace the EGB (PCB1).
Error Name/Error Condition/Major Cause/Solution
Software performance error
The software attempted to run an unexpected operation.
• Incorrect argument
• Incorrect internal parameter
• Insufficient working memory
• Abnormal performance caused by an error that cannot be detected in normal
To Next Page
Loading...
