Loading Paper into the Paper Tray
This section explains how to load paper in Tray 1 and Trays 2 to 3.
For information on how to load paper in other paper trays, see the following sections.
"Loading Paper into the Large Capacity Tray (LCT)", "Loading Paper into the Wide
LCT", "Loading Paper into the Two-tray Wide LCT"
Loading Paper into Tray 1
Tray 1 can hold A4 paper only.
Tray 1 can hold 8
1
/
2
× 11 paper only.
When loading paper in the left half of the paper tray, load at least 30 sheets.
• When paper loaded in the right side of Tray 1 runs out, paper on the left is automatically shifted to
the right. Do not pull out Tray 1 while the tray is moving paper; wait until sounds stop coming from
the tray.
1. Carefully pull out the paper tray until it stops.
2. Square the paper and load it print side down.
When you load paper into the right side of the tray, load the paper so its right edge is flush against
the right side of the tray.
When you load paper into the left side of the tray, load the paper so its left edge is flush against the
left side of the tray.
• Whole tray pulled out
Loading Paper into the Paper Tray
15
To Next Page
Loading...
