continuation bit in the flag byte of the Acknowledge Reply. If the host requests Acknowledgement
continuation by sending a command with ARQ bit and the Continuation bit set, the printer will
complete the RRL reply using Acknowledgement continuation. If the host requests RRL continuation
(by sending an RRL command with non-zero value in bytes 3 and 4) the printer will use
conventional RRL continuation to finish the reply. If the host requests both RRL and ACK
continuation, the printer will default to RRL continuation.
•
Bytes 8 and 9 are ignored when the resource type is ALL.
• Exception ID 0291..02 in bytes 6 and 7 are for invalid values. If either value is unsupported, then
the query is not understood and the reply is a single entry that sets the resource type to zero,
echoes other values, and sets the resource size to zero (not present).
Resource List Reply
Offset Range Meaning
Error
Code
0 X'FF UNORDERED LIST
1 X'01' END of LIST
X'04' -
X'nn'
LENGTH of this ENTRY
1. Device Control Command Set
66