Ridder LogicLink RLL400 - 7 Commissioning Instructions; Commissioning - Conditions and Starting Points

7. COMMISSIONING INSTRUCTIONS
The commissioning is only permied to approved personnel.
7.1 Commissioning - Condions and starng points
Make sure that the necessary moving direcon of the operated system agrees with:
• The control direcon of the Automac Control (ACS)
• The control direcon of the Manual Control (MC).
Obey the procedures that follow:
• §7.2 Check: Control direcon of the Automac Control (ACS)
• §7.3 Check: Control direcon of the Manual Control (MC).
Refer to the product manual of the used Ridder motor-gearbox at ridder.com to adjust the end
positions!
Do not go across the limits of the system. This prevents damage or
injury.
Before the system is put into operaon, the installer must always
make sure that the limit switch is correctly adjusted.
Make sure that there is no blockage of the system before the limit-
switch system is adjusted. This prevents damage or injury.
Ridder Drive Systems B.V.
T +31 (0)341 416 854 - F +31 (0)341 416 611 - I ridder.com
24