Ridder LogicLink RLL400 - 10 Environment; Decommissioning and Removal

10. ENVIRONMENT
10.1 Decommissioning and removal
Decommissioning and removal is only permied to approved personnel.
The starng points that follow are possible:
❶ During the work it is necessary to de-energize.
❷ Storage is necessary because of temporary removal.
❸ The product is at the end of the lifespan.
❶ Temporary decommissioning: Work
1. Refer to §2.2 “Precauons” and “Safety instrucons”.
2. De-energize the product.
3. Do the work (maintenance, service or such).
4. Energize the product.
5. The temporary decommissioning is completed.
❷ Temporary decommissioning: Product storage
1. Refer to §2.2 “Precauons” and “Safety instrucons”.
2. Disconnect the product from the electric circuit.
3. Disconnect the product mechanically from the system and remove the product (usually in
opposite sequence of the installaon).
4. Refer to §2.2 “Transport, storage and packaging” and obey the (applicable) instrucons and
condions.
5. The temporary decommissioning is completed.
Note: Obey the product manual for a subsequent installaon!
❸ Permanent decommissioning: End of lifespan
1. Refer to §2.2 “Precauons” and “Safety instrucons”.
2. Disconnect the product from the electric circuit.
3. Disconnect the product mechanically from the system and remove the product (usually in
opposite sequence of the installaon).
4. Make the product unserviceable and make a mark on the product. This prevents that the
product is (accidentally) used again.
5. The permanent decommissioning is completed. Refer to §10.2 “Waste disposal”.
Make sure that the system is in a stable and mechanically tension-
free condion and loosened parts (or the system) cannot hit
persons! This prevents damage or injury.
Make sure that the system is in a stable and mechanically tension-
free condion and loosened parts (or the system) cannot hit
persons! This prevents damage or injury.
Ridder Drive Systems B.V.
T +31 (0)341 416 854 - F +31 (0)341 416 611 - I ridder.com
30