RIGOL
1-2 © Copyright RIGOL Technologies, Inc. 2007.
User Manual for DM3000 Series
General Inspection
After you get a new DM3000 Digital Multimeter, you are suggested the following
steps to inspect the instrument.
1. Inspect the shipping container for damage.
Keep a damaged shipping container or cushioning material until the contents of
the shipment have been checked for completeness and the instrument has been
checked mechanically and electrically.
2. Check the accessories.
Accessories supplied with the instrument are listed in "Accessories" in front of
this manual.
If the contents are incomplete or damaged, please notify your RIGOL Sales
Representative.
3. Inspect the instrument.
In case any mechanical damage or defect, or if the instrument does not operate
properly or pass performance tests, notify your RIGOL Sales Representative.
If the shipping container is damaged, or the cushioning materials show signs of
stress, notify the carrier as well as your RIGOL sales office. Keep the shipping
materials for the carrier’s inspection.
RIGOL offices will arrange for reparation or replacement at RIGOL’s option without
waiting for claim settlement.
To Next Page
Loading...
