Rigol DM3000 Series User Manual

RIGOL
1-30 © Copyright RIGOL Technologies, Inc. 2007.
User Manual for DM3000 Series
Press Name button, you are allowed to create a name for the sensor reference
value document.
Figure 1-40
Press Type button, you are allowed to select the sensor type, include: DCV, DCI,
2-Wire resistance, and frequency.
Figure 1-41
Press Unit button, you are allowed to select the physical unit, include: , Pa, % , °, ℃
and F.
Figure 1-42
In New interface, press Define button to build the reference value table. The
reference value documents for each kind of sensor are different, so you need input
reference value in abundance.
Press Add button, you are allowed to input the measured and corresponding value to
reference value data.
Figure 1-43
Press SeG button, you are allowed to segment the reference value with different
arithmetic ( Line or Curve).
Press Done button, you have finished the input work, then you can use this sensor
reference immediately, or you can save it into the built-in storage space or your
U-disk for the future work.

Rigol DM3000 Series Specifications

General

Brand	Rigol
Model	DM3000 Series
Category	Multimeter
Language	English