Rigol DSA815 User Manual

Chapter 2 Front Panel Operation RIGOL
User’s Guide for DSA800/E Series
2-91
Marker->
Set the other system parameters (such as center frequency and reference level)
using the current marker readings. Press Marker-> to enable a marker
automatically if no marker is currently enabled.
Mkr->CF
Set the center frequency of the analyzer to the frequency of the current marker.
 If Normal marker is selected, the center frequency will be set to the
frequency of the current marker.
 If Delta, Delta Pair, or Span Pair marker is selected, the center frequency
will be set to the frequency of the Delta Marker.
 The function is invalid in Zero span mode.
Mkr->Step
Set the center frequency step of the analyzer to the frequency of the current
marker.
 If Normal marker is selected, the center frequency step will be set to the
frequency of the current marker.
 If Delta, Delta Pair or Span Pair marker is selected, the center frequency
step will be set to the frequency of the Delta Marker.
 The function is invalid in Zero span mode.
Mkr->Start
Set the start frequency of the analyzer to the frequency of the current marker.
 If Normal marker is selected, the start frequency will be set to the frequency
of the current marker.
 If Delta, Delta Pair or Span Pair marker is selected, the start frequency will
be set to the frequency of the Delta Marker.
 The function is invalid in Zero span mode.

Rigol DSA815 Specifications

General

Frequency Range	9 kHz to 1.5 GHz
Input Impedance	50 Ω
Input Connector	N-type female
Weight	4.25 kg
Power Supply	100-240 V AC, 50/60 Hz
Phase Noise	-80 dBc/Hz @ 10 kHz offset
Amplitude Accuracy	±1.5 dB
Display	8 inch LCD (800x480 pixels)
Video Bandwidth (VBW)	1 Hz to 3 MHz
Maximum Input Level	+20 dBm
Interfaces	USB, LAN
Resolution Bandwidth (RBW)	100 Hz to 1 MHz
Dimensions	361 mm x 178 mm x 128 mm