Rigol DSA815 User Manual

Chapter 5 Specifications RIGOL
User’s Guide for DSA800/E Series
5-1
Chapter 5 Specifications
Specifications are valid under the following conditions: the instrument is within the
calibration period, is stored for at least two hours at 0℃ to 50℃ temperature and
is warmed up for 40 minutes. Unless otherwise noted, the specifications in the
manual include the measurement uncertainty.
Typical (typ.): characteristic performance, which 80 percent of the measurement
results will meet at room temperature (approximately 25℃). This data is not
warranted and does not include the measurement uncertainty.
Nominal (nom.): the expected mean or average performance or a designed
attribute (such as the 50Ω connector). This data is not warranted and is measured
at room temperature (approximately 25℃).
Measured (meas.): an attribute measured during the design phase which can be
compared to the expected performance, such as the amplitude drift variation with
time. This data is not warranted and is measured at room temperature
(approximately 25℃).
Note: All charts in this manual are the measurement results of multiple instruments at room
temperature unless otherwise noted.

Rigol DSA815 Specifications

General

Frequency Range	9 kHz to 1.5 GHz
Input Impedance	50 Ω
Input Connector	N-type female
Weight	4.25 kg
Power Supply	100-240 V AC, 50/60 Hz
Phase Noise	-80 dBc/Hz @ 10 kHz offset
Amplitude Accuracy	±1.5 dB
Display	8 inch LCD (800x480 pixels)
Video Bandwidth (VBW)	1 Hz to 3 MHz
Maximum Input Level	+20 dBm
Interfaces	USB, LAN
Resolution Bandwidth (RBW)	100 Hz to 1 MHz
Dimensions	361 mm x 178 mm x 128 mm