Chapter 2 Front Panel Operation RIGOL
User’s Guide for DSA800/E Series
5. Operate
Enable or disable the display of the math trace and the default is Off.
Note: This menu is valid only when A or B is set to the selected type of trace.
Blank All
Disable all the traces displayed on the screen. This operation will stop the current
advanced measurement as there is not valid data source.
Pass/Fail
DSA800/E supports the Pass/Fail test function. In this function, the measured
curve is compared with the pre-edited curve. If the related rules are met, the
result is “Pass”; or else is “Fail”. The measurement interface is as shown in the
figure below.
Figure 2-11 Interface of Pass/Fail Test
To Next Page
Loading...
