6
Controls and Features
Comparator output terminals
The comparator signal is available at these terminals. The maximum applied
voltage is 24 V, and the maximum drive current varies as follows depending
on the impressed voltage.
50 mA (when the impressed voltage is 24 V)
25 mA (when the impressed voltage is 12 V)
10 mA (when the impressed voltage is 5 V)
Input select switch
Serves to select the input source. Available settings are ACCELEROMETER /
PREAMP 1 / PREAMP 2 / SERVO
/ SERVO .
Serial interface connector
Serves for connection of a computer or printer.
Servo input connector
The servo accelerometer (LS-10C or LS-20C) can be connected here.
Preamplifier 2 input connector
A piezoelectric accelerometer with integrated preamplifier can be connected
here.
Preamplifier 1 input connector
A piezoelectric accelerometer can be connected here via a preamplifier.
To Next Page
Loading...
Need help?
General
