47
Serial Interface
The VM-83 incorporates a serial interface that can be used to set measurement
parameters and control measurement using commands sent from a computer.
Measurement results can also be sent to the computer.
Using SC-31M or SC-31S adapters (option), a single computer can be used to
control up to 16 VM-83 units.
Transmission Principle
Transfer principle : asynchronous, half-duplex
Data word length : 8 bit
Stop bits : 2
Parity : none
Baud rate : 9600 bps, 19200 bps
Cable type : Generic cross-wired serial cable (null modem)
Connector on VM-83 9-pin D-sub, male
(When using an SC-31 adapter, cross-wired cable is
not required.)
To Next Page
Loading...
